 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
DOSAGE REQUIRED TO CHEMICALLY TREAT 120,000 GALLONS OF WATER
Parameter - Chemical Required Dosage
Free Chlorine 1 ppm 10 ppm
Calcium Hypochlorite 1.5 lbs 7.5 lbs.
Sodium Hypochlorite 1 gallon 5 gallons
Chlorine Gas 1 lb. 5 lbs
Neutralize Chlorine Decrease by 5 ppm Decrease by 10 ppm
Sodium Thiosulfate 3 lbs 6 lbs
Increase Total Alkalinity 10 ppm
Sodium Bicarbonate 18 lbs
Increase Calcium Hardness 10 ppm
Calcium Chloride 13 lbs
Increase Stabilizer 10 ppm
1 lb. = 16 ounces
1 gallon = 128 ounces
Parameter - Chemical Required Dosage
Free Chlorine 1 ppm 10 ppm
Calcium Hypochlorite 1.5 lbs 7.5 lbs.
Sodium Hypochlorite 1 gallon 5 gallons
Chlorine Gas 1 lb. 5 lbs
Neutralize Chlorine Decrease by 5 ppm Decrease by 10 ppm
Sodium Thiosulfate 3 lbs 6 lbs
Increase Total Alkalinity 10 ppm
Sodium Bicarbonate 18 lbs
Increase Calcium Hardness 10 ppm
Calcium Chloride 13 lbs
Increase Stabilizer 10 ppm
1 lb. = 16 ounces
1 gallon = 128 ounces
Amount of Soda Ash needed to raise pH to 7.4
Actual pH 25,000 gallons 50,000 gallons 100,000 gallons
6.6 3 3/4 lbs 7 1/2 lbs 15 lbs
6.8 3 lbs 6 lbs 12 lbs
7.0 2 1/4 lbs 4 3/4 lbs 8.5 lbs
7.2 2 lbs 3 1/4 lbs 6.5 lbs
To Add: Fill a clean bucket with water. Carefully add soda ash. For best results, dilute soda
ash as much as possible with water. Stir until dissolved with a clean rod. Pour solution down
Warning: Do not add more than 1 pound of soda ash per 10,000 gallons of water at a time
as it may cause the pool to cloud ("milky" consistency). Also, if your alkalinity is over 120
ppm, the addition of soda ash may also cause your water to cloud.
ash as much as possible with water. Stir until dissolved with a clean rod. Pour solution down
Warning: Do not add more than 1 pound of soda ash per 10,000 gallons of water at a time
as it may cause the pool to cloud ("milky" consistency). Also, if your alkalinity is over 120
ppm, the addition of soda ash may also cause your water to cloud.
Amount of Muriatic Acid needed to lower pH to 7.6
Actual pH 25,000 gallons 50,000 gallons 100,000 gallons
8.4 3/4 gallon 1 1/2 gallon 3 gallons
8.2 1/2 gallon 1 gallon 2 gallons
8.0 1 1/2 quarts 3 quarts 1 1/2 gallons
7.8 3 1/4 cups 1 1/2 quarts 3 quarts
Muriatic Acid to water. Carefully pour down side of pool distributing solution over as large
an area as possible. Close the pool for at least 30 minutes before allowing swimmers to
re-enter.
Warning: Never mix acid with any other chemicals. If splashed in eye, immediately irrigate
with water for at least 15 minutes with large amounts of water - Call 911. If splashed on
skin, wash with large amounts of water for at least 30 seconds.
1 quart = 32 ounces
1 cup = 8 ounces
an area as possible. Close the pool for at least 30 minutes before allowing swimmers to
re-enter.
Warning: Never mix acid with any other chemicals. If splashed in eye, immediately irrigate
with water for at least 15 minutes with large amounts of water - Call 911. If splashed on
skin, wash with large amounts of water for at least 30 seconds.
1 quart = 32 ounces
1 cup = 8 ounces
Aqua Logic Inc.
Aqua Logic Inc.
Phone: (952) 856-7550
Fax: (952) 856-7551
Fax: (952) 856-7551